• Iron Lynx@lemmy.world
    link
    fedilink
    arrow-up
    21
    ·
    7 months ago

    Really though, the most ardent defence of USC units is fuelled by great amounts of Copium. The US Customary set of measurements is several independent systems of measurements which often radically different origins and sometimes irrational conversions, all stacked upon each other and dressed in a trench coat. For instance, the mile has Roman origins while the inch and foot were defined separately, much later, and with a lot of regional variation. The French foot was longer than the English foot, which is why Napoleon was listed as 5’2" tall while he was actually closer to 5’9", or 1.71 m, which was pretty average for the time.

    Which one of these is more straightforward to calculate:

    • You are tasked with installing a rail along a 1 mile long bridge. You know you can use two half inch bolts to affix it every three feet. How many bolts do you need?

    • You are tasked with installing a rail along a 1,5 km long bridge. You know you can use two M12 bolts to affix it every metre. How many bolts do you need?

    Conversions within dimensions in USC require you to memorise arbitrary conversion numbers. Conversions within dimensions in SI require you to move the comma a few spots.

    Besides, if the US Customary system of units is so great, why did most of the world voluntarily switch to SI units?

    • Zerush@lemmy.mlOP
      link
      fedilink
      arrow-up
      7
      ·
      7 months ago

      Good example with the Bridge, it’s exact the point with the USC units, source of fatal errors.

    • Xavienth@lemmygrad.ml
      link
      fedilink
      arrow-up
      4
      ·
      edit-2
      7 months ago

      I don’t like the bridge example because the values were chosen (intentionally or not) conveniently for metric. Change it to every 4 feet or 1.3 metres and it’s no longer convenient in either system. There are better examples that demonstrate the superiority of metric.

      For example, pool cleaner says 1 unit per 10,000 gal or 40,000 L.

      21’ diameter, 3’ tall. So ~1000 ft³. Multiply by 1728/231 for gallons.

      7 m diameter, 1 m tall. So ~40 m³. Multiply by 1000 for litres.

      If you’re curious where 1728/231 comes from, there are 12³ (1728) in³ for a ft³. Then the gallon is defined as 231 in³